High-performance welding with 600 amperes

578
FRONIUS
The new TPS 600i power source from Fronius can supply up to 600 amperes of welding current at a welding voltage of 44 V and a 60 percent duty cycle.

The CU 1400i Pro cooling unit is optimally adapted to the TPS 600i and is easily capable of dispersing the thermal load typical of high performance welding. A sealless design and the use of a brushless and therefore wear-free pump motor guarantee greater system availability and durability than was previously possible.The cooling system works so efficiently with the appropriate water-cooled welding torch (MTW 700i) for manual and automated welding that the welding torch will return to room temperature in just a few moments after welding is completed, even following long periods of welding.
Completing the package are two new wirefeeders. Tailored to the new welding system, these wirefeeders are also driven by wear-free, brushless three-phase motors. The WF 30i can feed welding wire of up to 1.6 mm in diameter at a speed of up to 30 m/min., making it ideally suited to automated welding. The WF 15i will even feed 2.4 mm wires precisely and is therefore the perfect choice for repair and overlay welding.